In this video, I show you how to customix=ze your ODROID GO Advance from buttons to paint! make it the way you want! The case is made of polycarbonate so we will be using Tamiya polycarbonate Spray paint and if you want to keep the shell transparent just use the transparent polycarbonate paint.
As for the new buttons, Game Boy Pocket buttons fit perfectly with a little clipping.
Buy The Proper Polycarbonate Paint here:
Game Boy Pocket Buttons:
More Odroid Go Advance Videos:
Get One Here:
Or from AmeriDroid:
Odroid Go Advance Specs:
Processor CPU : RockChip RK3326(Quad-Core ARM Cortex-A35 1.3GHz)
GPU: Mali-G31 Dvalin
Memory 1GB (DDR3L 786Mhz, 32 Bits bus width)
Storage SPI Flash(16Mbytes Boot), Micro SD Card slot(UHS-1 Capable interface)
Display 3.5inch 320×480 TFT LCD (ILI9488, MIPI interface)
Audio Earphone Jack, 0.5Watt 8Ω Mono
Battery Li-Polymer 3.7V/3000mAh, Up to 10 hours of continuous game playing time
DC Jack 2.5mm diameter DC plug: A USB charging cable is included in the package.
External I/O USB 2.0 Host x 1, 10Pin port(I2C, GPIO, IRQ at 3.3Volt)
Input Buttons F1, F2, F3, F4, F5, F6, A, B, X, Y, Direction Pad, Left Shoulder, Right Shoulder, Analog joypstick
Power consumption Power consumption Game emulation: 100~115mA, Sleep mode: 5.3~5.8mA, Power off: 0.1mA
Follow Me On Twitter:
Follow Me On Instagram:
Equipment I Use:
Screen Capture Device:
Tool Kit:
Soldering Station:
Camera:
Tripod:
Raspberry Pi 3 B Plus:
Flirc Case:
DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission at no extra cost to you!
This video and Channel and Video are for viewers 14 years older and up. This video is not made for viewers under the age of 14. If you are under 14 years of age, you do not have permission to view this video.
THIS VIDEO IS FOR EDUCATIONAL PURPOSES ONLY!
#ODROID #GOAdvance #DIY
0 Comments